220 Volt Wire Size Calculator

The 220 volt wire size calculator will help you determine the appropriate electrical wire for your next house installation. Do you want to install a new bell, maybe a new water pump? Keep reading to find out how to size your cables.

The following information is required before we start:

• Wire size material since it affects the electrical resistivity.
• Distance between your energy source and the equipment you want to energize.
• The amount of current your equipment needs.

Once we have it all, we will use the following formula:

where:

• $\%\text{drop}$ — Allowable voltage drop, in %.
• $V$ — Source voltage, measured in volts.
• $I$ — Maximum current running through the wire, measured in amps;
• $\varrho$ — Resistivity of the conductor material, measured in ohm meters;
• $L$ — Length of the wire, measured in meters; and
• $A$ — Cross-sectional area of the wire measured in square meters.

The result will be expressed in mm² (if using the metric system).

It is common for wires to indicate their size in AWG (American Wire Gauge) units. Our wire gauge calculator relates circular cross area in mm² to AWG, but do not worry; our 220-volt wire size calculator also provides results in AWG.

1. Verify your connection will be 220 volt alternate current.
2. Choose your conductor material.
3. Define the amount of current your equipment need. For example, a 1 HP pump connected to a 220 volts single phase will require 3.39 amperes. Of course, never forget to verify the flow rate you need and verify system installation to be cavitation proof. You can also use the NPSH calculator in case you want to be sure.
4. Finally, input the length of your cable (remember it's a one-way distance).

As a result, the 220-volt wire size calculator will indicate the cross area of the cable you need to install.

Since you already know how to size a 220 volts wire, you can take a look at other calculators:

• Wire size calculator;
• DC wire size;
• 100 amp wire size;
• 12 volt wire size;
• Amp to wire size; and
• 24 volt wire size.

10 AWG or 2.38 mm of wire diameter. Try our 220-volt wire size calculator or follow these steps:

1. Multiply 20 amperes per two times cable distance and then by the material resistivity.
2. Divide the result by the voltage drop. Here, you get the cross-section area which you can convert to AWG by using internet charts. For the calculation, we assume a maximum wire size length of 39 m (one-way).

6 AWG. In our 220-volt wire size calculator:

1. Make sure you are in AC single-phase mode.
2. Add 50 amps in the Current section.
3. Define the one-way distance of your wire, and you will get 6 AWG as a result. For the calculation, we assume a maximum wire size length of 46 m (one-way).